A709 Gr 50 carbon steel plate sheet size and tolerance

DIN 17100 St37-2 steel plate belongs to the carbon and low alloy high strength steel plate. We can supply the different sizes of A709 Gr 50 carbon steel plate sheet, DIN 17100 St37-2 steel plate. And the rolling size of DIN 17100 St37-2 steel plate is following: the thickness range is 1.2-600mm, the width range is 1220-4200mm, and the length range is 5000-18000mm. Also note that the DIN 17100 St37-2 steel coil thickness should not exceed 25 mm.

The selection principle of steel plate for high-rise building is: it can not only make the structure safe and reliable, but also can save steel and reduce the cost. Different use conditions should have different quality requirements. In terms of the mechanical properties of steel such as A709 Gr 50 carbon steel plate sheet, yield point, tensile strength, elongation, cold bending property, impact toughness etc. are the indicators to measure the quality of steel. In the design of steel structure, the appropriate steel should be selected according to the characteristics of the structure. The selection of steel is not only an economic problem, but also related to the safety and service life of the structure.

Customer concept: customer first. Guided by market changes and guided by customer needs, we design the optimal product solutions and provide the best after-sales service. Partners: to reach a balance of interests with all stakeholders, to build a harmonious coexistence and win-win cooperation.

The effect of nitrogen (N) on the properties of A709 Gr 50 carbon steel plate sheet and so on steel is similar to that of carbon and phosphorus. With the increase of nitrogen content, the strength of steel can be significantly improved, especially the plasticity, especially toughness, and the weldability will be decreased, and the cold brittleness will be intensified. At the same time, aging tendency, cold brittleness and hot brittleness will be increased, which will damage the weldability and cold bending property of steel. Therefore, the nitrogen content in A709 Gr 50 carbon steel plate sheet and so on steel should be reduced and limited as much as possible. Generally, nitrogen content should not be higher than 0.018%.