How to distinguish the normal floating rust and rusting of SA572 grade 60 carbon steel plate sheet

With the development of China's SA572 grade 60 carbon steel plate sheet market economy, the company vigorously implements the strategy of industrialization, internationalization and diversification, promotes group operation, intensive development and lean management, and builds the company into a company with scientific development concept, continuous innovation vitality, excellent corporate culture and strong sense of social responsibility through rich series of SA572 grade 60 carbon steel plate sheet products and project portfolio and complete operation network And international first-class competitiveness of modern enterprises.

The typical hardness of NM500 steel plate is 500 HBW, so it can withstand severe wear. NM500 steel plate is very suitable for working in strong wear environment, such as high strength ore and corrosive materials. NM550 steel plate is a kind of wear-resistant steel plate with an average hardness of 550 HBW. SA572 grade 60 carbon steel plate sheet Its toughness is the same as that of NM500 steel plate, and it is used in high wear occasions. When the NM500 steel plate is upgraded to NM550 steel plate, the Brinell hardness is increased by 50 units, and the wear resistance life is prolonged without losing the toughness of the SA572 grade 60 carbon steel plate sheet steel plate.

SA572 grade 60 carbon steel plate sheet, 30CrMnSiA steel plate is a kind of low alloy high strength steel with medium carbon, high strength and good weldability. After quenching and tempering, 30CrMnSiA steel has high strength, enough toughness and good hardenability. After quenching and tempering, 30CrMnSiA steel can be used as grinding wheel shaft, gear and sprocket. 30CrMnSiA steel has good processability, small deformation and good fatigue resistance. 30CrMnSiA steel is usually used for shaft, piston parts, etc. It is used for various special wear-resistant parts of automobiles and airplanes.

The steel such as SA572 grade 60 carbon steel plate sheet delivered in the hot-rolled state has a certain degree of corrosion resistance due to the high temperature, so it can be stored in the open air. However, this layer of oxide scale also makes the hot-rolled steel surface rough and the size fluctuates greatly. Therefore, the steel with smooth surface, accurate size and good mechanical properties is required to be produced by using hot-rolled semi-finished products or finished products as raw materials and then cold rolling.

Our alloy steel plate and sheets are mainly used for weld fabrication of pressure vessels that require improved notch toughness for lower than ambient temperature service.Width: 1000mm to 4500mmThickness : 5mm to 150mmLength: 3000mm to 18000mmImpact tested 52° CSA572 grade 60 carbon steel plate sheet, Supply Condition: As Rolled, Normalized Rolling, Furnace Normalizing, Vacuum Degassing, Simulated Post-Weld Heat Treatment or as per customer requirement.

Our company has been established for 20 years and has accumulated rich experience in steel products. At the same time, it is often exported to Southeast Asia, Africa, South America and other countries. So you can rest assured that our SA572 grade 60 carbon steel plate sheet products and our prices are very favorable. Because we have our own factory, there is no other cost, we can also carry out machining and so on.

When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.