SA514 grade P steel material Material Steel Plate Size

SA514 grade P steel material,Standing at a new historical starting point, we adapt to the requirements of supply side structural reform, adhere to the overall strategy of "innovation driven, quality leading, quality improving and efficiency increasing, transformation and development", and constantly improve the development concept and development level with a forward-looking vision and grand vision. Now we have been ranked the International leading steel materials supplier.

The specifications available for , pressure vessel plates are: thickness 8-700mm, width 1500-4200mm, length 4000-17000mm, and unit weight up to 3000 tons Our company can provide cutting, welding, drilling and turning services if required Available flaw detection requirements: Z15-Z35 thickness direction performance requirements, high strength and toughness requirements, pressure vessel plate and other steel plates,SA514 grade P steel material.

SA514 grade P steel material,Q345B material is a low carbon alloy steel grade with good overall performance, low temperature performance, cold stamping performance, welding performance and machinability Q345 serues steel is widely used in bridges, vehicles, ships, buildings, pressure vessels Q represents the yield of this material, and the number 345 refers to the yield value of this material, which is around 345MPa As the thickness of the material increases, its yield value decreases,SA514 grade P steel material.

Weathering steel generally adopts the process route of fine material into the furnace-smelting (converter, electric furnace-microalloying treatment-argon blowing-LF refining-low superheat continuous casting (feeding rare earth wire)-controlled rolling and cooling The scrap steel is added into the furnace together with the charge, and smelted according to the conventional process After the steel is tapped, deoxidizers and alloys are added After the molten steel is treated with argon blowing, the molten steel is cast By adding rare earth elements to the steel, the weathering steel is purified and the content of inclusions is greatly reduced,SA514 grade P steel material.

DIN 17100 St37-2 steel plate belongs to the carbon and low alloy high strength steel plate. We can supply the different sizes of DIN 17100 St37-2 steel plate. And the rolling size of DIN 17100 St37-2 steel plate is following: the thickness range is 1.2-600mm, the width range is 1220-4200mm, and the length range is 5000-18000mm. Also note that the DIN 17100 St37-2 steel coil thickness should not exceed 25 mm.SA514 grade P steel material

Before delivering our hot rolled plate product we apply various tests to check the quality of carbon steel plates such as- mechanical test, chemical test, hardness test, toughness test, eddy current test, impact test, micro test, flaring test, flattening test, etc We are provided best packing for structural steel plates to avoid rust Our after-sales service team will contact you if you have any question,SA514 grade P steel material.