Top supplier and exporter of USt37-2 carbon steel plate sheet

The quality of USt37-2 carbon steel plate sheet shall not only meet the requirements of the standard, but also be higher or stricter than the product characteristics specified in the standard, including chemical composition, structure, physical properties, chemical properties and other requirements of USt37-2 carbon steel plate sheet buyer, such as packaging, delivery time, etc.. On the basis of the quality of USt37-2 carbon steel plate sheet in line with the corresponding standards, some buyers will put forward specific requirements according to their own use requirements, which is called technical agreement. That is, some specific factors should be met according to the buyer's requirements.

The capital letter H in S355J0H and S355J2H stands for ""Hollow section"", which respectively represents the pipe of S355J0 and S355J2.The Executive Standards of S355J0 steel and S355J2 steel, USt37-2 carbon steel plate sheet are both EN 10025-2, the difference is that they have different temperature requirements for impact energy: S355J0 - impact energy at 0 ℃ is required to be ≥ 27J. S355J2: impact energy at - 20 ℃ is required to be ≥ 27J.

Our team is a dynamic, but also mature and steady team. The talents are made of different ages. There are experienced ones, and also creative ones, that also makes our company culture diversified. We have complete department structure, to make the whole work procedure run smoothly. For every step, we have special person to be in charge and responsible for our customer and update information to the customer in time. So you just need not worry too much to purchase steel materials from our company.

Laser cutting is that the horizontal laser beam emitted by the laser changes into a vertical downward laser beam through the 45° total reflector, and then focuses through the lens, forming a tiny spot at the focal point. When the spot hits the material, the material is heated to the vaporization temperature quickly, and evaporates to form a hole. With the movement of the beam on the material such as USt37-2 carbon steel plate sheet, the auxiliary gas (carbon dioxide gas, oxygen, Nitrogen, etc.) blow away the melted slag, make the hole continuously form a very narrow width (such as about 0.1mm) cutting seam, and complete the cutting of materials.